Do not your hands into the water that has been heated for the inspection.
Touching the heated water could result in burns.
89422C
1.INSPECT ENGINE COOLANT TEMPERATURE SENSOR
Partially immerse the sensor in water and warm up the water.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | Approx. 20°C (68°F) | 2.32 to 2.59 kΩ |
| 1 - 2 | Approx. 80°C (176°F) | 0.310 to 0.326 kΩ |
| *a | Component without harness connected
(Engine Coolant Temperature Sensor) |
*b | Resistance |
| *c | Temperature | *d | Acceptable Range |
If the result is not as specified, replace the engine coolant temperature sensor.
When checking the engine coolant temperature sensor in water, keep the terminals dry. After the check, wipe the engine coolant temperature sensor dry.