Home › Engine / Hybrid System › 2KD-FTV ENGINE CONTROL › ECM
RM3250E _51 Engine / Hybrid System _038013 2KD-FTV ENGINE CONTROL _0189624 ECM A

2KD-FTV ENGINE CONTROL  ECM  INSTALLATION  


PROCEDURE

Hide 89668A 1.INSTALL NO. 2 ECM BRACKET

a.

Install the No. 2 ECM bracket with the 2 screws.

Torque:
3.0 N*m (31 kgf*cm, 27 in.*lbf)


Hide 89667A 2.INSTALL NO. 1 ECM BRACKET

a.

Install the No. 1 ECM bracket with the 2 screws.

Torque:
3.0 N*m (31 kgf*cm, 27 in.*lbf)


Hide 89533 3.INSTALL 4WD CONTROL ECU (for 4WD)

Hide 89661 4.INSTALL ECM

a.

Install the ECM, No. 1 and No. 2 ECM bracket with the bolt and 2 nuts.

Torque:
for bolt : 8.0 N*m (82 kgf*cm, 71 in.*lbf)
for nut : 5.5 N*m (56 kgf*cm, 49 in.*lbf)


b.

for 4WD:

Connect the 2 4WD control ECU connector.


c.

Connect the 4 ECM connectors and clamp.


Hide 55510 5.INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY

Hide 6.PERFORM REGISTRATION

Click hereEngine / Hybrid System>2KD-FTV ENGINE CONTROL>ECD SYSTEM>REGISTRATION

HINT:

Only perform registration when the ECM is replaced, either by itself or in any of the following combinations.

·

ECM and Fuel Supply Pump

·

ECM and Diesel Throttle Body Assembly

·

ECM and Injector Assembly

·

ECM and Engine Assembly