Home › Engine / Hybrid System › 2KD-FTV ENGINE CONTROL › CRANKSHAFT POSITION SENSOR
RM3250E _51 Engine / Hybrid System _038013 2KD-FTV ENGINE CONTROL _0189628 CRANKSHAFT POSITION SENSOR A

2KD-FTV ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 11301L 1.INSTALL CRANKSHAFT POSITION SENSOR

a.

Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.


b.

Install the crankshaft position sensor with the bolt to the timing gear cover.

Torque:
8.5 N*m (87 kgf*cm, 75 in.*lbf)


c.

Attach the 4 clamps and connect the crankshaft position sensor connector.

NOTICE:

Insert the crankshaft position sensor wire harness into the protrusions of the timing gear cover.



Hide 51441 2.INSTALL NO. 1 ENGINE UNDER COVER