Home › Engine / Hybrid System › 2KD-FTV INTAKE / EXHAUST › EXHAUST MANIFOLD W/ TURBOCHARGER
RM3250E _51 Engine / Hybrid System _038017 2KD-FTV INTAKE / EXHAUST _0189644 EXHAUST MANIFOLD W/ TURBOCHARGER A

2KD-FTV INTAKE / EXHAUST  EXHAUST MANIFOLD W/ TURBOCHARGER  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
A343691

To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.


The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the injector assembly removal/installation are shown below.

PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 51441 3.REMOVE NO. 1 ENGINE UNDER COVER

Hide 51442 4.REMOVE NO. 2 ENGINE UNDER COVER

Hide 17410 5.REMOVE FRONT EXHAUST PIPE ASSEMBLY

Hide 17705 6.REMOVE AIR CLEANER CAP SUB-ASSEMBLY WITH AIR CLEANER HOSE

a.
A346623

Disconnect the intake air temperature sensor connector and detach the 2 clamps.


b.

Loosen the hose clamp, and then remove the air cleaner hose from the turbocharger sub-assembly.


c.

Disconnect the ventilation hose and remove the 2 bolts and air cleaner cap sub-assembly with air cleaner hose.


Hide 17801 7.REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

a.
A345134

Remove the air cleaner element sub-assembly from the air cleaner case sub-assembly.


Hide 17701 8.REMOVE AIR CLEANER CASE SUB-ASSEMBLY

a.
A344949

Disconnect the 3 wire harness clamps.


b.
A344950

Remove the 3 bolts and air cleaner case sub-assembly.


Hide 12278 9.REMOVE PCV HOSE HEAT INSULATOR

a.

Remove the 2 bolts and PCV hose heat insulator.


Hide 17291 11.REMOVE TURBINE OUTLET ELBOW

a.
A346624

Remove the 2 bolts, 4 nuts, turbine outlet elbow with turbocharger stay and gasket from the turbocharger sub-assembly.


b.

Remove the 2 bolts and turbocharger stay from the turbine outlet elbow.


Hide 17201 12.REMOVE TURBOCHARGER SUB-ASSEMBLY

a.
A346625

Remove the 2 bolts and manifold stay from the exhaust manifold and engine mount bracket.


b.

Remove the 2 bolts, union bolt and 2 gaskets from the cylinder block sub-assembly.


c.
A346626

Remove the 3 nuts, turbocharger sub-assembly with turbo oil inlet pipe sub-assembly and gasket.


d.
A110356

Remove the 2 nuts, turbo oil pipe sub-assembly and gasket from the turbocharger sub-assembly.


Hide 17141 13.REMOVE EXHAUST MANIFOLD

a.
A252011

Remove the 8 nuts, 8 plate washers and exhaust manifold.


b.

Remove the gasket.