23670
1.CHECK INJECTOR ASSEMBLY
Start the engine and drive the vehicle until the engine coolant temperature reaches 60°C (140°F) or higher.
Allow the engine to idle for 1 minute or more.
Connect the GTS to the DLC3.
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Data List / Injection Volume and Injector Feedback Val. #1 to #4.
| Tester Display |
|---|
| Injection Feedback Val #1 |
| Injection Feedback Val #2 |
| Injection Feedback Val #3 |
| Injection Feedback Val #4 |
Read the values when the engine is idling.
Check that the "Injector Feedback Val. #1 to #4" values are within the specification.
| Tester Display | Engine Condition | Specified Condition |
|---|---|---|
| Injection Volume | Idling | 3 to 10 mm3/st |
| Injector Feedback Val. #1
Injector Feedback Val. #2 Injector Feedback Val. #3 Injector Feedback Val. #4 |
Idling | -3.0 to 3.0 mm3/st |
If the result is not as specified, replace the fuel injector assembly.
2.CHECK INJECTOR COMPENSATION CODE
If the injector compensation code is not correctly registered, it may cause malfunctions.
Read the injector compensation code.
Click hereEngine / Hybrid System>2GD-FTV ENGINE CONTROL>ECD SYSTEM>REGISTRATION
Check that the compensation code of the installed injector assembly is the same as the code registered in the ECM. If the code is not the same, register the injector compensation code on the injector assembly.
Click hereEngine / Hybrid System>2GD-FTV ENGINE CONTROL>ECD SYSTEM>REGISTRATION