The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the crankshaft position sensor removal/installation are shown below.
1.REMOVE AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission)
2.REMOVE MANUAL TRANSMISSION ASSEMBLY (for Manual Transmission)
31210
3.REMOVE CLUTCH COVER ASSEMBLY (for Manual Transmission)
for R151
for RC61, RC61F
Click hereDrivetrain>CLUTCH>CLUTCH UNIT(for RC60, RC61)>REMOVAL
31250
4.REMOVE CLUTCH DISC ASSEMBLY (for Manual Transmission)
for R151
for RC61, RC61F
Click hereDrivetrain>CLUTCH>CLUTCH UNIT(for RC60, RC61)>REMOVAL
13405
5.REMOVE FLYWHEEL SUB-ASSEMBLY
11355
6.REMOVE REAR END PLATE
12581A
7.REMOVE NO. 1 CYLINDER BLOCK INSULATOR
12585
8.REMOVE NO. 5 CYLINDER BLOCK INSULATOR
27148C
9.REMOVE CONNECTING WIRE
Disconnect the 2 connectors and clamp and remove the connecting wire.
10.REMOVE CRANKSHAFT POSITION SENSOR HARNESS BRACKET
Remove the bolt and crankshaft position sensor harness bracket from the cylinder block sub-assembly.
11401Q
11.REMOVE CRANKSHAFT POSITION SENSOR
Remove the bolt and crankshaft position sensor from the rear oil seal retainer.