DTC P0630 is set when the Vehicle Identification Number (VIN) is not stored in the ECM or the input VIN is not accurate. Input the VIN with the GTS.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| P0630 | VIN not Programmed or Mismatch - ECM / PCM | VIN not stored in ECM
Input VIN in ECM not accurate (1 Trip detection logic). |
ECM | Comes on | DTC stored |
| DTC No. | DTC Detection Drive Pattern |
|---|---|
| P0630 | Ignition switch ON for 5 seconds or more |
Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS ON.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
|---|---|
| DTC P0630 is output | A |
| DTC P0630 and other DTCs are output | B |
If P0630 is set, the VIN must be input to the ECM using the GTS. However, all DTCs are cleared automatically by the GTS when inputting the VIN. If DTCs other than P0630 are set, check them first.
If any DTCs other than P0630 are output, troubleshoot those DTCs first.
A
B
Click hereEngine / Hybrid System>1GD-FTV ENGINE CONTROL>ECD SYSTEM(w/ DPF)>DIAGNOSTIC TROUBLE CODE CHART
Input the VIN.
Click hereEngine / Hybrid System>1GD-FTV ENGINE CONTROL>ECD SYSTEM(w/ DPF)>REGISTRATION
| Proceed to |
|---|
| NEXT |
NEXT