Home › Steering › POWER ASSIST SYSTEMS › VANE PUMP(for 1GD-FTV, 2GD-FTV)
RM3250E _55 Steering _038049 POWER ASSIST SYSTEMS _0190434 VANE PUMP(for 1GD-FTV, 2GD-FTV) A

POWER ASSIST SYSTEMS  VANE PUMP(for 1GD-FTV, 2GD-FTV)  INSTALLATION  


PROCEDURE

Hide 44320 1.INSTALL VANE PUMP ASSEMBLY

a.

Install the vane pump with the 2 bolts.

Torque:
21 N*m (214 kgf*cm, 15 ft.*lbf)


Hide 44411 2.CONNECT PRESSURE FEED HOSE

a.

Install a new gasket to the pressure feed tube assembly.


b.
C322723C01
0.406,1.406 0.49,1.083 true 0.292,1.438 0.5,1.688 0.208,0.25 10 true *a
*a Stopper


Install the union bolt and connect the pressure feed tube to the vane pump assembly.

Torque:
49 N*m (500 kgf*cm, 36 ft.*lbf)

HINT:

Make sure that the stopper of the pressure feed tube touches the front housing.



Hide 44348A 3.CONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE

a.

Connect the oil reservoir to pump hose to the vane pump assembly and slide the hose clip.


b.

Connect the connector to the power steering oil pressure switch.


Hide 16361A 5.INSTALL FAN AND GENERATOR V BELT

Hide 6.ADD POWER STEERING FLUID

Hide 8.CHECK FOR POWER STEERING FLUID LEAK