Home › Drivetrain › CLUTCH › CLUTCH MASTER CYLINDER(w/o Turn Over)
RM3250E _52 Drivetrain _038032 CLUTCH _0190443 CLUTCH MASTER CYLINDER(w/o Turn Over) A

CLUTCH  CLUTCH MASTER CYLINDER(w/o Turn Over)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1.DRAIN CLUTCH FLUID

NOTICE:

Wash off clutch fluid immediately if it comes into contact with a painted surface.


Hide 31434 2.DISCONNECT CLUTCH RESERVOIR TUBE

a.
C333654

Slide the clip and disconnect the clutch reservoir tube from the clutch master cylinder assembly.

HINT:

Use a container to collect the fluid.



Hide 31481 3.DISCONNECT CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE

a.
C333655

Using a union nut wrench, disconnect the clutch master cylinder to flexible hose tube.

HINT:

Use a container to collect the fluid.



Hide 4.DISCONNECT CLUTCH MASTER CYLINDER PUSH ROD CLEVIS

Hide 31410 5.REMOVE CLUTCH MASTER CYLINDER ASSEMBLY

a.
C324306

w/o Master Cylinder Bracket:

Remove the 2 nuts, clutch master cylinder assembly and gasket.


b.

w/ Master Cylinder Bracket:

Remove the 2 nuts, clutch master cylinder assembly, master cylinder bracket and 2 gaskets.


Hide 6.REMOVE CLUTCH MASTER CYLINDER PUSH ROD CLEVIS

a.

Loosen the lock nut, and then remove the master cylinder push rod clevis and lock nut from the push rod.

NOTICE:

When loosening the lock nut, be sure to hold the clevis in place by its square portion.