When using a vise, place aluminum plates between the part and vise.
When using a vise, do not overtighten it.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.REMOVE STEERING TURN PRESSURE TUBE (for 2WD)
Using a union nut wrench, remove the 2 steering turn pressure tubes.
Remove the 4 O-rings.
2.REMOVE STEERING TURN PRESSURE TUBE (for 4WD and Pre-Runner)
for LHD:
Using a union nut wrench, remove the 2 steering turn pressure tubes.
Remove the 4 O-rings.
for RHD:
Remove the union bolt and 2 gaskets.
Using a union nut wrench, remove the 2 steering turn pressure tubes.
Remove the 3 O-rings.
3.SECURE POWER STEERING LINK ASSEMBLY
Using SST, secure the power steering link assembly.
45047
4.REMOVE TIE ROD END SUB-ASSEMBLY LH
| *1 | Rack End |
| *a | Matchmark |
Place matchmarks on the tie rod end sub-assembly LH, lock nut and rack end.
Loosen the lock nut and remove the tie rod end sub-assembly LH and lock nut.
45046
5.REMOVE TIE ROD END SUB-ASSEMBLY RH
Use the same procedure described for the LH side.
6.REMOVE STEERING RACK BOOT CLAMP LH
Using a screwdriver, remove the steering rack boot clamp LH.
Be careful not to damage the steering rack boot LH.
7.REMOVE STEERING RACK BOOT CLAMP RH
Use the same procedure described for the LH side.
8.REMOVE STEERING RACK BOOT CLIP LH
Using pliers, remove the steering rack boot clip LH.
Be careful not to damage the steering rack boot.
9.REMOVE STEERING RACK BOOT CLIP RH
Use the same procedure described for the LH side.
10.REMOVE STEERING RACK BOOT LH
11.REMOVE STEERING RACK BOOT RH