The ECM memory contains the programs for the normal and PWR shift patterns.
By following the programs corresponding to the signals from the combination switch assembly (pattern select switch), park/neutral position switch and other various sensors, the ECM switches the shift solenoid valves on and off, and controls the transmission gear ratio.
| *1 | Combination Switch Assembly (Pattern Select Switch) |
Remove the combination switch assembly (pattern select switch).
Click hereDrivetrain>AC60E AUTOMATIC TRANSMISSION / TRANSAXLE>PATTERN SELECT SWITCH>REMOVAL
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 3 (PWR) - 2 (E) | Combination switch (PWR) pushed | Below 1 Ω |
| 3 (PWR) - 2 (E) | Combination switch (PWR) not pushed | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Front view of wire harness connector
(to Combination Switch Assembly (Pattern Select Switch)) |
Disconnect the combination switch assembly (pattern select switch) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I5-2 (E) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Rear view of wire harness connector
(to ECM) |
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| G85-12 (PWMS) - Body ground | Combination switch (PWR) pushed | Below 1 Ω |
| G85-12 (PWMS) - Body ground | Combination switch (PWR) not pushed | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG