Home › Engine / Hybrid System › 2GD-FTV ENGINE CONTROL › AIR FUEL RATIO SENSOR › 2015.06–2016.03
RM3250E _51 Engine / Hybrid System _038005 2GD-FTV ENGINE CONTROL _0192297 AIR FUEL RATIO SENSOR A

2GD-FTV ENGINE CONTROL  AIR FUEL RATIO SENSOR  INSTALLATION  


PROCEDURE

Hide 89467B 1.INSTALL AIR FUEL RATIO SENSOR

HINT:

Perform "Inspection After Repairs" after replacing the air fuel ratio sensor.

Click hereEngine / Hybrid System>2GD-FTV ENGINE CONTROL>ECD SYSTEM>INITIALIZATION

w/ DPF:

Click hereEngine / Hybrid System>2GD-FTV ENGINE CONTROL>ECD SYSTEM(w/ DPF)>INITIALIZATION


a.
A349885C01
0.688,0.583 0.781,0.583 0.781,0.583 1.021,1.094 true 1.656,1.917 1.854,2.094 0.198,0.177 10 true *a 0.354,0.5 0.688,0.677 0.333,0.177 10 true SST
*a Torque Wrench Fulcrum Length


Using SST, install the air fuel ratio sensor.

SST
09224-00011  

Torque:
Specified tightening torque : 44 N*m (449 kgf*cm, 32 ft.*lbf)

HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)): 37.7 N*m (384 kgf*cm, 28 ft.*lbf)




b.

Connect the connector and clamp.


Hide 53882F 3.INSTALL FRONT FENDER SEAL RH

a.

for 2WD:

i.

Install the front fender seal RH with 5 new clips.



b.

for 4WD and Pre-Runner:

i.

Install the front fender seal RH with 6 new clips.