82125J
1.INSTALL TRANSMISSION WIRE
Coat a new O-ring with ATF and install it to the transmission wire connector.
Install the transmission wire to the automatic transmission case sub-assembly with the bolt.
Connect the 7 connectors to the solenoid valves.
Coat each O-ring of 2 ATF temperature sensors with ATF and connect the 2 ATF temperature sensors with the 2 clamps and 2 bolts.
| Item | Length |
|---|---|
| Bolt A | 12 mm (0.472 in.) |
| Bolt B | 36 mm (1.42 in.) |
82121
2.CONNECT ENGINE WIRE
Connect the engine wire to the transmission wire.
Push up the lever until the claw of the engine wire connector makes a connection sound.
35330
3.INSTALL VALVE BODY OIL STRAINER ASSEMBLY
Coat a new O-ring with ATF and install it to the valve body oil strainer assembly.
Install the valve body oil strainer assembly with the 4 bolts.
35106
4.INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY
Remove the gasket and be careful not to spill oil on the contacting surfaces of the transmission case and automatic transmission oil pan sub-assembly.
| *1 | Magnet |
Install the 4 magnets.
Install a new gasket on the automatic transmission oil pan sub-assembly.
Install the automatic transmission oil pan sub-assembly with the 20 bolts.
12371A
5.INSTALL REAR ENGINE MOUNTING INSULATOR
51204
6.INSTALL NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY
7.ADD AUTOMATIC TRANSMISSION FLUID