Home › Drivetrain › A750F AUTOMATIC TRANSMISSION / TRANSAXLE › PARK / NEUTRAL POSITION SWITCH
RM3250E _52 Drivetrain _038029 A750F AUTOMATIC TRANSMISSION / TRANSAXLE _0193343 PARK / NEUTRAL POSITION SWITCH A

A750F AUTOMATIC TRANSMISSION / TRANSAXLE  PARK / NEUTRAL POSITION SWITCH  INSTALLATION  


PROCEDURE

Hide 84540 1.INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

HINT:

Make sure that the manual valve lever shaft has not been rotated prior to installing the park/neutral position switch as the detent spring may become detached from the manual valve lever shaft.


a.

Clean the bolt and the bolt hole.


b.

Apply adhesive to 2 or 3 threads on the end of the bolt.

Adhesive:

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent



c.

Temporarily install the park/neutral position switch assembly with the bolt.

HINT:

Tighten the bolt to the specified torque when adjusting the park/neutral position switch assembly.



d.
C155871C03
1.938,1.281 2.458,0.292 2.458,0.292 2.292,0.292 true 2.083,0.219 2.333,0.406 0.25,0.188 10 false *1
*1 Lock Washer


Install the lock washer and the nut to the park/ neutral position switch assembly.

Torque:
6.9 N*m (70 kgf*cm, 61 in.*lbf)


e.
C283583N01
1.448,0.094 1.604,0.292 0.156,0.198 10 false N 2.542,0.146 2.698,0.344 0.156,0.198 10 false R 2.792,0.813 2.948,1.01 0.156,0.198 10 false P

Turn the control shaft lever LH clockwise until it stops, and then turn it counterclockwise 2 notches to set it to the N position.


f.

Move the shift lever to N.


g.
C283078C02
1.979,1.573 2.844,1.573 true 1.969,0.927 2.833,0.927 true 2.885,0.833 3.198,0.99 0.313,0.156 10 false *a 2.885,1.49 3.198,1.646 0.313,0.156 10 false *b
*a Neutral Basic Line
*b Groove


Align the neutral basic line with the groove as shown in the illustration, and tighten the bolt.

Torque:
12.8 N*m (131 kgf*cm, 9 ft.*lbf)


h.

Using a screwdriver, bend the tabs of the lock washer.


i.

Connect the park/neutral position switch connector.