Home › Engine / Hybrid System › 2KD-FTV STARTING › STARTER(for 2.2 kW Type)
RM3250E _51 Engine / Hybrid System _038020 2KD-FTV STARTING _0193367 STARTER(for 2.2 kW Type) A

2KD-FTV STARTING  STARTER(for 2.2 kW Type)  INSTALLATION  


PROCEDURE

Hide 28100 1.INSTALL STARTER ASSEMBLY

a.

Temporarily install the starter assembly and ground cable with the bolt.


b.

Temporarily install the clutch flexible hose bracket with the bolt.


c.

Tighten the 2 bolts.

Torque:
68 N*m (693 kgf*cm, 50 ft.*lbf)


d.

Install the starter wire with the nut.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


e.

Connect the starter connector.


f.

Install the starter terminal cap.


Hide 2.CONNECT CLUTCH RELEASE CYLINDER ASSEMBLY

Hide 53882K 3.INSTALL FRONT FENDER SEAL LH

a.

for 4WD and Pre-Runner:

Install the front fender seal LH with new 6 clips.


b.

for 2WD:

Install the front fender seal LH with new 5 clips.


Hide 51442 4.INSTALL NO. 2 ENGINE UNDER COVER (for 4WD and Pre-Runner)

Hide 51410 5.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY (for 4WD and Pre-Runner)

Hide 6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION