1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
53882F
3.REMOVE FRONT FENDER SEAL LH
Remove the 5 clips and front fender seal LH.
4.DISCONNECT CLUTCH RELEASE CYLINDER ASSEMBLY
28100
5.REMOVE STARTER ASSEMBLY
Disconnect the starter connector.
Disconnect the terminal cap.
Remove the nut and disconnect the starter wire.
Remove the bolt and disconnect the clutch flexible hose bracket.
Remove the bolt and starter assembly.