Home › Engine / Hybrid System › 2TR-FE STARTING › STARTER(except 2.0 kW Type)
RM3250E _51 Engine / Hybrid System _038028 2TR-FE STARTING _0193402 STARTER(except 2.0 kW Type) A

2TR-FE STARTING  STARTER(except 2.0 kW Type)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 53882F 3.REMOVE FRONT FENDER SEAL LH

a.

for 2WD:

Remove the 5 clips and front fender seal LH.


b.

for 4WD:

Remove the 6 clips and front fender seal LH.


Hide 4.DISCONNECT CLUTCH RELEASE CYLINDER ASSEMBLY (for Manual Transmission)

Hide 28100 5.REMOVE STARTER ASSEMBLY

a.
A343608

Disconnect the starter connector.


b.

Disconnect the terminal cap.


c.

Remove the nut and disconnect the starter wire.


d.

for Manual Transmission:

i.
A343609

Remove the bolt and disconnect the clutch flexible hose bracket.


ii.

Remove the bolt and starter assembly.



e.

for Automatic Transmission:

i.
A343610

Remove the 2 bolts and starter assembly.