Home › Engine / Hybrid System › 2TR-FE STARTING › STARTER(except 2.0 kW Type)
RM3250E _51 Engine / Hybrid System _038028 2TR-FE STARTING _0193402 STARTER(except 2.0 kW Type) A

2TR-FE STARTING  STARTER(except 2.0 kW Type)  INSTALLATION  


PROCEDURE

Hide 28100 1.INSTALL STARTER ASSEMBLY

a.

for Manual Transmission:

i.

Temporarily install the starter assembly with the bolt.


ii.

Temporarily install the clutch flexible bracket with the bolt.


iii.

Tighten the 2 bolts.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)



b.

for Automatic Transmission:

i.

Install the starter assembly with the 2 bolts.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)



c.

Connect the starter wire with the nut.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


d.

Connect the terminal cap.


e.

Connect the starter connector.


Hide 2.CONNECT CLUTCH RELEASE CYLINDER ASSEMBLY (for Manual Transmission)

Hide 53882F 3.INSTALL FRONT FENDER SEAL LH

a.

for 2WD:

Install the front fender seal LH with 5 new clips.


b.

for 4WD:

Install the front fender seal LH with 6 new clips.


Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION