Home › Engine / Hybrid System › 1GD-FTV COOLING › WATER PUMP
RM3250E _51 Engine / Hybrid System _037977 1GD-FTV COOLING _0193408 WATER PUMP A

1GD-FTV COOLING  WATER PUMP  INSTALLATION  


PROCEDURE

Hide 16100 1.INSTALL ENGINE WATER PUMP ASSEMBLY

a.
A343591C01
2.854,0.51 3.01,0.708 0.156,0.198 10 true 1 0.375,1.958 0.531,2.156 0.156,0.198 10 true 2 0.583,1.104 0.74,1.302 0.156,0.198 10 true 3 0.656,0.302 0.813,0.5 0.156,0.198 10 true 4 2.135,0.427 2.292,0.625 0.156,0.198 10 true 5 2.708,1.802 2.865,2 0.156,0.198 10 true 6 2.094,1.844 2.25,2.042 0.156,0.198 10 true 7 1.75,1.979 1.917,2.177 0.167,0.198 10 true 8
V100135

Bolt A
V100136

Bolt B


Temporarily install a new gasket and the engine water pump assembly with the 8 bolts.

Bolt Length:
Item Length
Bolt A 45 mm (1.77 in.)
Bolt B 65 mm (2.56 in.)



b.

Tighten the 8 bolts in the order shown in the illustration.

Torque:
25 N*m (255 kgf*cm, 18 ft.*lbf)


Hide 16284 2.CONNECT NO. 1 TURBO WATER HOSE

a.

Connect the No. 1 turbo water hose to the engine water pump assembly and slide the hose clamp to secure the hose.


Hide 16268 3.CONNECT NO. 1 WATER BY-PASS PIPE

a.
A343595C01
1.833,1.458 2,1.292 2,1.292 2.167,1.292 false 2.219,1.219 2.531,1.417 0.313,0.198 10 false *a
*a Claw


Install a new gasket to the No. 1 water by-pass pipe as shown in the illustration.

HINT:

Make sure that the claws of the gasket are facing the No. 1 water by-pass pipe.



b.

Connect the No. 1 water by-pass pipe to the engine water pump assembly with the 3 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


c.

Attach the wire harness clamp and connect the 2 connectors to the turbocharger sub-assembly.