Home › Engine / Hybrid System › 1TR-FE ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL
RM3250E _51 Engine / Hybrid System _037998 1TR-FE ENGINE MECHANICAL _0193492 REAR CRANKSHAFT OIL SEAL A

1TR-FE ENGINE MECHANICAL  REAR CRANKSHAFT OIL SEAL  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear engine oil seal removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Gas leaks from exhaust system Inspection after repair Poor idle, engine start, etc. (Click here)

PROCEDURE

Hide 33030 1.REMOVE MANUAL TRANSMISSION UNIT ASSEMBLY

Hide 31210 2.REMOVE CLUTCH COVER ASSEMBLY

Hide 31250 3.REMOVE CLUTCH DISC ASSEMBLY

Hide 13405 4.REMOVE FLYWHEEL SUB-ASSEMBLY

a.
A349291C01
0.583,1.5 0.75,1.5 0.75,1.5 1.177,1.104 true 2.573,1.625 2.885,1.781 0.313,0.156 10 false *a 0.292,1.417 0.75,1.615 0.458,0.198 10 false SST
*a Hold


Using SST, hold the crankshaft.

SST
09213-54015  (91651-60855)
09330-00021  


b.
A349292

Remove the 10 bolts and flywheel sub-assembly.


Hide 11381A 5.REMOVE REAR ENGINE OIL SEAL

a.
A349754C01
0.5,0.25 0.667,0.25 0.667,0.25 1.563,1.115 true 0.563,1.563 0.75,1.917 0.75,1.917 0.917,1.917 true 0.917,1.833 1.167,2 0.25,0.167 10 true *a 0.333,0.167 0.646,0.323 0.313,0.156 10 false *b
*a Cut Position
*b Protective Tape


Using a knife, cut off the lip of the rear engine oil seal.


b.

Using a screwdriver, pry out the rear engine oil seal.

NOTICE:
·

Do not damage the surface of the rear engine oil seal press fit hole or the crankshaft.

·

After removing the rear engine oil seal, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.



HINT:

Tape the screwdriver tip before use.