Home › Engine / Hybrid System › 1TR-FE ENGINE MECHANICAL › CYLINDER BLOCK
RM3250E _51 Engine / Hybrid System _037998 1TR-FE ENGINE MECHANICAL _0193494 CYLINDER BLOCK A

1TR-FE ENGINE MECHANICAL  CYLINDER BLOCK  REPAIR  


CAUTION / NOTICE / HINT

HINT:
·

Bore all 4 cylinders to fit the O/S piston outside diameter.

·

Replace all the piston rings with ones to match the O/S pistons.



PROCEDURE

Hide 1.BORE CYLINDER

a.

Prepare 4 new O/S pistons.


b.
G037359C01
3.208,1.604 3.396,1.823 0.188,0.219 10 false *a
*a Distance


Using a micrometer, measure the piston diameter at right angles to the piston center line where the distance from the piston end is as specified.

Standard piston diameter (O/S 0.50):

86.451 to 86.486 mm (3.4036 to 3.4050 in.)


Distance:

11.4 mm (0.449 in.)



c.

Calculate the amount each cylinder is to be rebored as follows.

Size to be rebored = P + C - H
P Piston diameter
C Piston oil clearance: 0.004 to 0.052 mm (0.000157 to 0.00205 in.)
H Allowance for honing: 0.02 mm (0.000787 in.) or less


d.

Bore and hone the cylinders to the calculated dimensions.

Maximum honing:

0.02 mm (0.000787 in.)


NOTICE:

Excess honing will destroy the finished roundness.



e.

Using a cylinder gauge, measure the cylinder bore diameter and calculate the honing allowance.

HINT:

Honing allowance = cylinder bore diameter - (piston diameter + oil clearance)



f.

Finish the cylinder bore using the calculated value.


g.
A112877C05
1.938,1.063 2.51,0.479 2.51,0.479 2.75,0.479 true 1.802,0.896 1.177,0.26 1.177,0.26 1.031,0.26 true 0.833,0.188 1.156,0.417 0.323,0.229 10 false *a 2.833,0.396 3.104,0.604 0.271,0.208 10 false *b 1.719,1.823 1.938,2.021 0.219,0.198 10 false A 1.719,2.125 1.948,2.333 0.229,0.208 10 false B 1.719,2.438 1.958,2.656 0.24,0.219 10 false C 2.448,1.802 2.719,2.01 0.271,0.208 10 false *c 2.469,2.448 2.74,2.656 0.271,0.208 10 false *c 0.656,1.917 0.927,2.125 0.271,0.208 10 false *d
*a Thrust Direction
*b Axial Direction
*c 10 mm (0.394 in.)
*d 70 mm (2.76 in.)
V100135

Front


Using a cylinder gauge, measure the cylinder bore diameter.

Standard oil clearance:

0.004 to 0.052 mm (0.000157 to 0.00205 in.)