Home › Engine / Hybrid System › 1GD-FTV STARTING › STARTER(for 2.2 kW Type)
RM3250E _51 Engine / Hybrid System _037979 1GD-FTV STARTING _0193789 STARTER(for 2.2 kW Type) A

1GD-FTV STARTING  STARTER(for 2.2 kW Type)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 53882K 3.REMOVE FRONT FENDER SEAL LH

a.

for 4WD and Pre-Runner:

Remove the 6 clips and front fender seal LH.


b.

for 2WD:

Remove the 5 clips and front fender seal LH.


Hide 51410 4.REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY (for 4WD and Pre-Runner)

Hide 51442 5.REMOVE NO. 2 ENGINE UNDER COVER (for 4WD and Pre-Runner)

Hide 6.DISCONNECT CLUTCH RELEASE CYLINDER ASSEMBLY (for Manual Transmission)

a.

Remove the 2 bolts and disconnect the clutch release cylinder assembly.


Hide 28100 7.REMOVE STARTER ASSEMBLY

a.

Remove the starter terminal cap.


b.

Disconnect the starter connector.


c.
C322555

Remove the nut and disconnect the starter wire.


d.
C326403

for Automatic Transmission:

Remove the nut, 2 bolts and starter assembly and disconnect the ground cable.


e.

for Manual Transmission:

i.
C322556

Remove the bolt and disconnect the clutch flexible hose bracket.


ii.

Remove the bolt and starter assembly and disconnect the ground cable.