28100
1.INSTALL STARTER ASSEMBLY
for Automatic Transmission:
Temporarily install the starter assembly and ground cable with the nut and 2 bolts.
Tighten bolt A and nut B.
for Manual Transmission:
Temporarily install the starter assembly and ground cable with the 2 bolts.
Install the clutch release cylinder assembly with the 2 bolts.
Tighten the 2 bolts.
Connect the starter wire with the nut.
Connect the starter connector.
Install the starter terminal cap.
53882K
2.INSTALL FRONT FENDER SEAL LH
for 4WD and Pre-Runner:
Install the front fender seal LH with 6 new clips.
for 2WD:
Install the front fender seal LH with 5 new clips.
51442
3.INSTALL NO. 2 ENGINE UNDER COVER (for 4WD and Pre-Runner)
51410
4.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY (for 4WD and Pre-Runner)
5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION