Home › General › SPECIFICATIONS › 1TR-FE FUEL
RM3250E _V1 General _038082 SPECIFICATIONS _0176417 1TR-FE FUEL F

SPECIFICATIONS  1TR-FE FUEL  SERVICE DATA  


FUEL SYSTEM
Standard fuel pressure at idle 321 to 327 kPa (3.27 to 3.33 kgf/cm2, 46.5 to 47.4 psi)
Remains as specified for 5 minutes after engine stopped 147 kPa (1.5 kgf/cm2, 21 psi) or higher

FUEL INJECTOR
Fuel injector assembly Resistance Standard 11.6 to 12.4 Ω at 20°C (68°F)
Injection volume Standard 68 to 82 cc (4.1 to 5.0 cu.in.) per 15 seconds
Difference between each injector 14 cc (0.9 cu.in.) or less
Fuel leakage 1 drop or less per 25 minutes

FUEL PUMP (for Long Wheelbase)
Fuel pump Resistance Standard 0.2 to 3.0 Ω at 20°C (68°F)

FUEL PUMP (for Short Wheelbase)
Fuel pump Resistance Standard 0.2 to 3.0 Ω at 20°C (68°F)

FUEL SENDER GAUGE
Fuel sender gauge Voltage Float position is F (upper) Standard 4.25 to 4.61 V*
Float position is E (lower) Standard 0.34 to 0.70 V*

*: The output voltage changes depending on the voltage applied to the terminals.