Home › General › SPECIFICATIONS › 2TR-FE LUBRICATION
RM3250E _V1 General _038082 SPECIFICATIONS _0176455 2TR-FE LUBRICATION F

SPECIFICATIONS  2TR-FE LUBRICATION  SERVICE DATA  


LUBRICATION SYSTEM (Standard Oil Pressure)
Condition Specified Condition
Idle 29 kPa (0.3 kgf/cm2, 4.2 psi) or higher
3000 rpm 160 to 490 kPa (1.6 to 5.0 kgf/cm2, 23 to 71 psi)

OIL PRESSURE SWITCH
Tester Connection Condition Specified Condition
1 - Body ground Engine stopped Below 1 Ω
Engine idling 10 kΩ or higher

OIL PUMP
Tip clearance Standard 0.040 to 0.160 mm (0.00157 to 0.00630 in.)
Maximum 0.260 mm (0.0102 in.)
Side clearance Standard 0.030 to 0.070 mm (0.00118 to 0.00276 in.)
Maximum 0.130 mm (0.00512 in.)
Body clearance Standard 0.250 to 0.325 mm (0.00984 to 0.0128 in.)
Maximum 0.425 mm (0.0167 in.)

Standard Oil Grade
Oil Grade Oil Viscosity (SAE)
API grade SL "Energy-Conserving", SM "Energy-Conserving", SN "Resource-Conserving" or ILSAC multigrade engine oil 0W-20
5W-20
5W-30
10W-30
API grade SL, SM or SN multigrade engine oil 15W-40
20W-50*

*: This grade of engine oil cannot be used for Euro IV or higher.

Standard Capacity
Item Specified Condition
Drain and refill without oil filter sub-assembly change 5.3 liters (5.6 US qts, 4.7 Imp. qts)
Drain and refill with oil filter sub-assembly change 5.6 liters (5.9 US qts, 4.9 Imp. qts)
Dry fill 6.3 liters (6.7 US qts, 5.5 Imp. qts)