Home › Engine / Hybrid System › 2GD-FTV ENGINE CONTROL › ECD SYSTEM(w/ DPF)
RM3250E _51 Engine / Hybrid System _038005 2GD-FTV ENGINE CONTROL _0199793 ECD SYSTEM(w/ DPF) J

2GD-FTV ENGINE CONTROL  ECD SYSTEM(w/ DPF)  After Treatment Control System  


CAUTION / NOTICE / HINT

NOTICE:

After replacing the exhaust manifold converter sub-assembly (DPF catalyst), clear the thermal deterioration data stored in the ECM.

Click hereEngine / Hybrid System>2GD-FTV ENGINE CONTROL>ECD SYSTEM(w/ DPF)>INITIALIZATION


PROCEDURE

1.TAKE SNAPSHOT DURING IDLING AND 4000 RPM (PROCEDURE 1)
a.

Connect the GTS to the DLC3.


b.

Start the engine and turn the GTS on.


c.

Enter the following menus: Powertrain / Engine and ECT / Data List / All Data.


d.

Take a snapshot of the following Data List items.

HINT:
·

A snapshot can be used to compare vehicle data from the time of the malfunction to normal data and is very useful for troubleshooting. The data in the list below is that of a normal vehicle, but as the data varies between individual vehicles, this data should only be used for reference.

·

Check the Data List at idling and at 4000 rpm with no load after the engine is warmed up.




Result:
Proceed to
NEXT



NEXT

2.READ VALUE USING GTS (CATALYST DIFFERENTIAL PRESS)
2.READ VALUE USING GTS (CATALYST DIFFERENTIAL PRESS)
a.

Check Catalyst Differential Press in the snapshot taken in procedure 1 when the engine was running at 4000 rpm with no load.

Result:
Result Proceed to
Catalyst Differential Press is more than 0.27 A
Except above B




A

3.REPLACE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY

B

5.PERFORM PM FORCED REGENERATION
3.REPLACE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY
a.

Replace the exhaust manifold converter sub-assembly (DPF catalytic converter).

Click hereEngine / Hybrid System>2GD-FTV EMISSION CONTROL>MONOLITHIC CONVERTER(w/o DPF)>REMOVAL


Result:
Proceed to
NEXT



NEXT

4.PERFORM CATALYST RECORD CLEAR AND DETERIORATION RECORD CLEAR
4.PERFORM CATALYST RECORD CLEAR AND DETERIORATION RECORD CLEAR
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON and turn the GTS on.


c.

Enter the following menus: Powertrain / Engine and ECT / Utility / Catalyst Record Clear.

Powertrain > Engine > Utility
Tester Display
Catalyst Record Clear
50005 234 178
Powertrain > Engine > Utility
Tester Display
DPF Deterioration Record Clear
50005 234 253

Result:
Proceed to
NEXT



NEXT

5.PERFORM PM FORCED REGENERATION
5.PERFORM PM FORCED REGENERATION
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON and turn the GTS on.


c.

Clear the DTCs.

Powertrain > Engine > Clear DTCs
50002 234

d.

Warm up the engine (engine coolant temperature is 75°C (167°F) or higher).


e.

Perform PM forced regeneration.

Click hereEngine / Hybrid System>2GD-FTV EMISSION CONTROL>EMISSION CONTROL SYSTEM>ON-VEHICLE INSPECTION

Result:

PM forced regeneration completes normally.



Result:
Proceed to
OK
NG



OK

END

NG

REPLACE EXHAUST FUEL ADDITION INJECTOR ASSEMBLY