Home › Engine / Hybrid System › 2GD-FTV STARTING › STARTER(for 2.7 kW Type)
RM3250E _51 Engine / Hybrid System _038012 2GD-FTV STARTING _0199962 STARTER(for 2.7 kW Type) A

2GD-FTV STARTING  STARTER(for 2.7 kW Type)  DISASSEMBLY  


PROCEDURE

Hide 28120 1.REMOVE STARTER YOKE ASSEMBLY

a.
A360242

Remove the nut and disconnect the lead wire from terminal C.


b.

Remove the 2 bolts.


c.

Pull out the starter yoke assembly together with the starter armature assembly.


d.

Remove the felt washer from the starter armature assembly.


Hide 28150 2.REMOVE MAGNET STARTER SWITCH ASSEMBLY

a.
A102626

Remove the 3 screws and magnet starter switch assembly.


Hide 28011 3.REMOVE STARTER CLUTCH SUB-ASSEMBLY

a.
A306552C01
0.25,1.26 0.25,0.646 0.25,0.646 0.396,0.646 false 1.073,0.833 1.073,0.406 1.073,0.406 1.208,0.406 false 2.698,0.396 2.917,0.177 2.917,0.177 3.042,0.177 false 0.865,1.729 0.948,1.5 0.948,1.5 1.073,1.5 false 1.844,1.76 1.979,1.948 1.979,1.948 2.125,1.948 false 1.24,1.854 1.375,2.042 1.375,2.042 1.521,2.042 false 0.479,0.573 0.792,0.729 0.313,0.156 10 false *1 1.271,0.333 1.583,0.49 0.313,0.156 10 false *2 3.104,0.104 3.417,0.26 0.313,0.156 10 false *3 1.167,1.417 1.479,1.573 0.313,0.156 10 false *4 1.563,1.958 1.875,2.115 0.313,0.156 10 false *5 2.167,1.875 2.479,2.031 0.313,0.156 10 false *6
*1 Return Spring
*2 Starter Clutch Sub-assembly
*3 Starter Drive Housing Assembly
*4 Clutch Roller
*5 Retainer
*6 Idler Gear


Remove the return spring, idler gear, clutch roller, retainer and starter clutch sub-assembly from the starter drive housing assembly.


b.
A115020C13
2.677,0.417 2.563,0.417 2.563,0.417 2.135,0.74 false 2.76,0.323 3.042,0.51 0.281,0.188 10 false *a
*a Magnet Hand


Using a magnet hand, remove the steel ball from the clutch shaft hole.


Hide 28140 4.REMOVE STARTER BRUSH HOLDER ASSEMBLY

a.
A360243

Remove the 2 screws and commutator end frame from the starter yoke assembly.


b.
A102629

Disconnect the 4 starter brushes from the starter brush holder assembly.

i.

Using a screwdriver, pull back the spring.


ii.

Disconnect the brush from the starter brush holder assembly.



c.

Remove the starter brush holder assembly from the starter yoke assembly.


Hide 28160 5.REMOVE STARTER ARMATURE ASSEMBLY

a.

Remove the starter armature assembly from the starter yoke assembly.