Home › Engine / Hybrid System › 2GD-FTV STARTING › STARTER(for 2.7 kW Type)
RM3250E _51 Engine / Hybrid System _038012 2GD-FTV STARTING _0199962 STARTER(for 2.7 kW Type) A

2GD-FTV STARTING  STARTER(for 2.7 kW Type)  INSTALLATION  


PROCEDURE

Hide 28100 1.INSTALL STARTER ASSEMBLY

a.

for Automatic Transmission:

i.

Temporarily install the starter assembly and ground cable with the nut.


ii.

Temporarily install the starter assembly with the bolt.


iii.

Tighten the bolt and nut.

Torque:
68 N*m (693 kgf*cm, 50 ft.*lbf)



b.

for Manual Transmission:

i.

Temporarily install the starter assembly and ground cable with the bolt.


ii.

Temporarily install the clutch flexible hose bracket with the bolt.


iii.

Tighten the bolt and nut.

Torque:
68 N*m (693 kgf*cm, 50 ft.*lbf)



c.

Connect the starter wire with the nut.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


d.

Connect the starter connector.


e.

Install the starter terminal cap.


Hide 2.CONNECT CLUTCH RELEASE CYLINDER ASSEMBLY (for Manual Transmission)

Hide 53882K 3.INSTALL FRONT FENDER SEAL LH

a.

for 4WD and Pre-Runner

Install the front fender seal LH with new 6 clips.


b.

for 2WD:

Install the front fender seal LH with new 5 clips.


Hide 51442 4.INSTALL NO. 2 ENGINE UNDER COVER (for 4WD and Pre-Runner)

Hide 51410 5.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY (for 4WD and Pre-Runner)

Hide 6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION