Home › General › SPECIFICATIONS › 2TR-FE BATTERY / CHARGING
RM3250E _V1 General _038082 SPECIFICATIONS _0176531 2TR-FE BATTERY / CHARGING F

SPECIFICATIONS  2TR-FE BATTERY / CHARGING  SERVICE DATA  


CHARGING SYSTEM
Battery Standard Specific Gravity 1.25 to 1.29 at 20°C (68°F)
Standard Voltage 12.6 to 12.8 V at 20°C (68°F)
Fuse Standard Resistance Below 1 Ω
Charging circuit without load Standard Current 10 A or higher
Standard Voltage 13.5 to 14.35 V
Charging circuit with load Standard Current 30 A or higher

HARNESS AND CONNECTOR
Tester Connection Condition Specified Condition
C53-16 (LIN) - C9-2 (LIN) Always Below 1 Ω
C53-16 (LIN) or C9-2 (LIN) - Body ground Ignition switch off
(while LIN communication is stopped)
10 kΩ or higher

GENERATOR BRUSH HOLDER ASSEMBLY
Brush length Standard exposed brush length 9.5 to 11.5 mm (0.374 to 0.453 in.)
Minimum exposed brush length 4.5 mm (0.177 in.)

GENERATOR ROTOR ASSEMBLY
Tester Connection Condition Specified Condition
Slip ring - Slip ring 20°C (68°F) 1.85 to 2.25 Ω
Slip ring - Rotor core Always 10 kΩ or higher

Slip ring diameter Standard diameter 14.2 to 14.8 mm (0.559 to 0.583 in.)
Minimum diameter 14.0 mm (0.551 in.)