RM3250E
_V1
General
_038082
SPECIFICATIONS
_0176505
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS
F
SPECIFICATIONS BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS SERVICE DATA
Deceleration Sensor (for 4WD and Pre-Runner without VSC)
| Tester Connection
|
Condition
|
Specified Condition
|
| 1 (GL1) - Battery negative (-) lead
|
Horizontal
|
Approx. 2.25 V
|
| 1 (GL1) - Battery negative (-) lead
|
Sensor is tilted forward
|
Approx. 0.45 to 2.25 V
|
| 1 (GL1) - Battery negative (-) lead
|
Sensor is tilted rearward
|
Approx. 2.25 to 4.05 V
|
VSC OFF Switch
| Tester Connection
|
Switch Condition
|
Specified Condition
|
| 3 - 6
|
Pressed
|
Below 1 Ω
|
| Not pressed
|
10 kΩ or higher
|
Downhill Assist Control Switch
| Tester Connection
|
Switch Condition
|
Specified Condition
|
| 1 - 4
|
Pressed
|
Below 1 Ω
|
| Not pressed
|
10 kΩ or higher
|
Stop Light Control Relay (STOP LP)
| Tester Connection
|
Condition
|
Specified Condition
|
| 3 - 4
|
Battery positive (+) voltage not applied to terminal 1 and battery negative (-) voltage applied to terminal 2
|
Below 1 Ω
|
| Battery positive (+) voltage applied to terminal 1 and battery negative (-) voltage to terminal 2
|
10 kΩ or higher
|
| 3 - 5
|
Battery positive (+) voltage not applied to terminal 1 and battery negative (-) voltage applied to terminal 2
|
10 kΩ or higher
|
| Battery positive (+) voltage applied to terminal 1 and battery negative (-) voltage to terminal 2
|
Below 1 Ω
|