Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › FRONT PROPELLER SHAFT ASSEMBLY(for TSAM Made) › from 2016.01
RM3250E _52 Drivetrain _038038 DRIVE SHAFT / PROPELLER SHAFT _0242560 FRONT PROPELLER SHAFT ASSEMBLY(for TSAM Made) G

DRIVE SHAFT / PROPELLER SHAFT  FRONT PROPELLER SHAFT ASSEMBLY(for TSAM Made)  INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:
·

When using a vise, place aluminum plates between the part and vise.

·

When using a vise, do not overtighten it.



PROCEDURE

Hide 37140 1.INSPECT FRONT PROPELLER SHAFT ASSEMBLY

F052087

a.

Using a dial indicator, check the front propeller shaft assembly runout.

Maximum runout:

0.8 mm (0.0314 in.)


If the front propeller shaft assembly runout is more than the maximum, replace the front propeller shaft assembly.


Hide 2.INSPECT SPIDER BEARING

a.

Check the spider bearings for wear or damage.

If necessary, replace the spider bearings.


b.
C113731

Check the spider bearing axial play by turning the yoke while holding the front propeller shaft assembly tightly.

Maximum bearing axial play:

0.05 mm (0.00196 in.)


If the axial play is more than the maximum, replace the spider bearings.