Home › Engine / Hybrid System › 5L-E FUEL › FUEL INJECTION NOZZLE › from 2016.01
RM3250E _51 Engine / Hybrid System _049912 5L-E FUEL _0242564 FUEL INJECTION NOZZLE A

5L-E FUEL  FUEL INJECTION NOZZLE  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 23701 4.REMOVE INJECTION PIPE SUB-ASSEMBLY

a.
A370264C01
0.083,0.198 0.417,0.438 0.333,0.24 10 false *a 0.073,2.438 0.396,2.698 0.323,0.26 10 true *b
*a for Nozzle Holder and Nozzle Set Side
*b for Injection Pump Assembly Side


Remove the 2 nuts and 2 injection pipe clamps.


b.

Using a 17 mm union nut wrench, loosen the union nuts and remove the 4 injection pipe sub-assemblies from the nozzle holder and nozzle set and injection pump assembly.


Hide 19871 5.REMOVE NO. 1 GLOW PLUG CONNECTOR

Hide 23760 6.REMOVE NOZZLE LEAKAGE PIPE ASSEMBLY

a.
A370301

Slide the clamp and disconnect the fuel hose from the nozzle leakage pipe assembly.


b.

Remove the 4 ring packing setting nuts, nozzle leakage pipe assembly and 4 ring packing washers from the nozzle holder and nozzle set.


Hide 23600 7.REMOVE NOZZLE HOLDER AND NOZZLE SET

a.
A121942N01
0.385,0.688 0.625,0.688 0.625,0.688 1.313,1.146 true 0.073,0.604 0.417,0.813 0.344,0.208 10 true SST

Using SST, remove the 4 nozzle holder and nozzle sets, 4 injection nozzle seats and injection nozzle seat gaskets.

SST
09268-64010  (09268-64020)

HINT:

Arrange the nozzle holder and nozzle sets in correct order.