Home › Power Source / Network › 2TR-FE BATTERY / CHARGING › GENERATOR(for 90A Type) › from 2016.01
RM3250E _57 Power Source / Network _038061 2TR-FE BATTERY / CHARGING _0243373 GENERATOR(for 90A Type) A

2TR-FE BATTERY / CHARGING  GENERATOR(for 90A Type)  REASSEMBLY  


PROCEDURE

Hide 27415 1.INSTALL GENERATOR PULLEY WITH CLUTCH

a.
A317242C02
1.083,0.521 1.594,0.521 false 1.01,1.49 1.521,1.49 false 0.896,0.427 1.208,0.583 0.313,0.156 10 false *a 0.729,1.417 1.188,1.615 0.458,0.198 10 false SST
*a T50 "TORX" Socket Wrench


Set SST and a T50 "TORX" socket wrench as shown in the illustration.

SST
09820-30010  


b.

Secure the generator assembly in a vise between aluminum plates.


c.
A318017C01
1.219,0.177 1.583,0.177 1.583,0.177 1.875,1 false 1.073,2.583 1.438,2.583 1.438,2.583 1.667,1.177 true 1.885,2.635 2.198,2.792 0.313,0.156 10 false *a 2.865,3.063 3.177,3.219 0.313,0.156 10 false *b 1.042,0.073 1.354,0.229 0.313,0.156 10 false *c 0.781,2.49 1.24,2.688 0.458,0.198 10 false SST
*a Hold
*b Turn
*c T50 "TORX" Socket Wrench


While holding SST in place, rotate the T50 "TORX" socket wrench counterclockwise, and install the generator pulley with clutch

Torque:
80 N*m (816 kgf*cm, 59 ft.*lbf)

NOTICE:

Check that the drive end frame is secured in the vise tightly.



Hide 27416 2.INSTALL GENERATOR PULLEY CAP

a.

Install a new generator pulley cap to the generator pulley with clutch.