Home › Engine / Hybrid System › 5L-E INTAKE / EXHAUST › EXHAUST PIPE › from 2016.01
RM3250E _51 Engine / Hybrid System _049914 5L-E INTAKE / EXHAUST _0243537 EXHAUST PIPE A

5L-E INTAKE / EXHAUST  EXHAUST PIPE  INSTALLATION  


PROCEDURE

Hide 17410 1.INSTALL FRONT EXHAUST PIPE ASSEMBLY

a.

Install a new gasket and the front exhaust pipe assembly to the exhaust manifold with 3 new nuts.

Torque:
62 N*m (632 kgf*cm, 46 ft.*lbf)


b.
A362749N01
0.979,0.771 1.167,0.948 0.188,0.177 10 true A 0.781,1.115 0.969,1.292 0.188,0.177 10 true B

Install the No. 1 exhaust pipe support bracket with the 2 bolts.

Torque:
for bolt A : 71 N*m (724 kgf*cm, 52 ft.*lbf)
for bolt B : 68.7 N*m (701 kgf*cm, 51 ft.*lbf)


c.

Install the clamp with the bolt.

Torque:
19 N*m (194 kgf*cm, 14 ft.*lbf)


Hide 17402 2.INSTALL FRONT NO. 2 EXHAUST PIPE SUB-ASSEMBLY

a.
A128853

Using a vernier caliper, measure the free length of the compression spring.

Minimum free length:

40 mm (1.57 in.)


If the free length is less than the minimum, replace the compression spring.


b.
A076194C40
2.042,1.573 1.51,1.927 1.51,1.927 1.354,1.927 true 2.438,0.979 3.042,0.979 true 1.125,1.833 1.365,2.031 0.24,0.198 10 false *1 3.104,0.885 3.354,1.083 0.25,0.198 10 false *a
*1 Gasket
*a Wooden Block


Using a plastic-faced hammer and wooden block, tap on a new gasket until its surface is flush with the front exhaust pipe assembly.

NOTICE:
·

Be sure to install the gasket so that it is facing in the correct direction.

·

Do not reuse the gasket.

·

Do not damage the gasket.

·

When connecting the exhaust pipe, do not push on the gasket with the exhaust pipe.




c.

Connect the front No. 2 exhaust pipe sub-assembly to the exhaust pipe support.


d.

Install the front No. 2 exhaust pipe sub-assembly with the 2 compression springs and 2 bolts.

Torque:
43 N*m (438 kgf*cm, 32 ft.*lbf)


Hide 17430 3.INSTALL TAILPIPE ASSEMBLY

a.

Install a new gasket to the front No. 2 exhaust pipe sub-assembly.


b.

Connect the tailpipe assembly to the 4 exhaust pipe supports.


c.

Install the tailpipe assembly with the 2 nuts and 2 bolts.

Torque:
43 N*m (438 kgf*cm, 32 ft.*lbf)


Hide 4.INSPECT FOR EXHAUST GAS LEAK

If gas is leaking, tighten the areas necessary to stop the leak. Replace damaged parts as necessary.