Home › Engine / Hybrid System › 1TR-FE INTAKE / EXHAUST › INTAKE SYSTEM › from 2016.01
RM3250E _51 Engine / Hybrid System _038001 1TR-FE INTAKE / EXHAUST _0181659 INTAKE SYSTEM G

1TR-FE INTAKE / EXHAUST  INTAKE SYSTEM  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the air leaks from intake system removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Air leaks from intake system Inspection after repair Poor idle, engine start, etc. (Click here)

CAUTION:
A343690

To prevent injury due to contact with an operating fan and generator V-belt or cooling fan, keep your hands and clothing away from the fan and generator V-belt and cooling fans when working in the engine compartment with the engine running.


PROCEDURE

Hide 1.INSPECT INTAKE SYSTEM

CAUTION:

To prevent injury due to contact with an operating fan and generator V-belt or cooling fan, keep your hands and clothing away from the fan and generator V-belt and cooling fans when working in the engine compartment with the engine running.


HINT:

Perform "Inspection After Repair" after repairing air leaks in the intake system.

Click hereEngine / Hybrid System>1TR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION


a.

for RHD:

Check that there is no air suction at the points shown in the illustration.

A349773


b.

for LHD:

Check that there is no air suction at the points shown in the illustration.

A355834