85035
1.INSPECT WASHER NOZZLE SUB-ASSEMBLY (for LHD)
for Europe:
With the engine switch turned to on (IG), check the position that the washer fluid hits the windshield.
Washer fluid hits the windshield in the areas shown in the illustration.
| *a | Upper Limit | *b | Standard |
| *c | Lower Limit | - | - |
| Area | Measurement | Area | Measurement |
|---|---|---|---|
| A | 165 mm (6.4960 in.) | B | 208 mm (8.1890 in.) |
| C | 133 mm (5.2362 in.) | D | 245 mm (9.6457 in.) |
If the result is not as specified, replace the washer nozzle sub-assembly.
except Europe:
With the engine switch turned to on (IG), check the position that the washer fluid hits the windshield.
Washer fluid hits the windshield in the areas shown in the illustration.
| *a | Upper Limit | *b | Standard |
| *c | Lower Limit | - | - |
| Area | Measurement | Area | Measurement |
|---|---|---|---|
| A | 184 mm (7.2441 in.) | B | 215 mm (8.4646 in.) |
| C | 115 mm (4.5276 in.) | D | 197 mm (7.7559 in.) |
If the result is not as specified, replace the washer nozzle sub-assembly.
85035
2.INSPECT WASHER NOZZLE SUB-ASSEMBLY (for RHD)
for Europe:
With the engine switch turned to on (IG), check the position that the washer fluid hits the windshield.
Washer fluid hits the windshield in the areas shown in the illustration.
| *a | Upper Limit | *b | Standard |
| *c | Lower Limit | - | - |
| Area | Measurement | Area | Measurement |
|---|---|---|---|
| A | 165 mm (6.4960 in.) | B | 208 mm (8.1890 in.) |
| C | 133 mm (5.2362 in.) | D | 245 mm (9.6457 in.) |
If the result is not as specified, replace the washer nozzle sub-assembly.
except Europe:
With the engine switch turned to on (IG), check the position that the washer fluid hits the windshield.
| *a | Upper Limit | *b | Standard |
| *c | Lower Limit | - | - |
Washer fluid hits the windshield in the areas shown in the illustration.
| Area | Measurement | Area | Measurement |
|---|---|---|---|
| A | 184 mm (7.2441 in.) | B | 215 mm (8.4646 in.) |
| C | 115 mm (4.5276 in.) | D | 197 mm (7.7559 in.) |
If the result is not as specified, replace the washer nozzle sub-assembly.