44320
1.INSTALL VANE PUMP ASSEMBLY
Install the vane pump with the 2 bolts and nut.
48 N*m (489 kgf*cm, 35 ft.*lbf)
63 N*m (642 kgf*cm, 46 ft.*lbf)
Turn nut (C) while holding bolt (B).
2.INSTALL VANE PUMP PULLEY
| *a | Hold |
| *b | Turn |
Using SST, install the vane pump pulley to the vane pump assembly.
44411
3.CONNECT PRESSURE FEED HOSE
Install a new gasket to the pressure feed hose.
Connect the pressure feed hose to the vane pump assembly the union bolt.
Make sure that the stopper of the pressure feed hose touches the front housing.
44348A
4.CONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE
Connect the No. 1 oil reservoir to pump hose to the oil reservoir sub-assembly and slide the hose clamp.
5.INSTALL VANE PUMP V BELT
6.ADD POWER STEERING FLUID
7.ADJUST POWER STEERING FLUID
8.CHECK FOR FLUID LEAKS