Home › Engine / Hybrid System › 5L-E COOLING › WATER PUMP › from 2016.01
RM3250E _51 Engine / Hybrid System _049915 5L-E COOLING _0244983 WATER PUMP G

5L-E COOLING  WATER PUMP  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 16711 1.REMOVE FAN SHROUD

Hide 11302 2.REMOVE NO. 1 TIMING BELT COVER

Hide 3.INSPECT FOR COOLANT LEAK

HINT:
·

The sliding surface inside the engine water pump assembly is lubricated by engine coolant. As some engine coolant is discharged during normal operation, coolant residue (solids) may be found on the drain plug or the bottom of the engine water pump assembly. Also, engine coolant may leak if foreign matter enters the engine water pump assembly, however the sealing performance will recover when the foreign matter is pushed out or breaks into fine pieces. In this case, check the area around the engine water pump assembly.

·

Before performing this inspection, check that there is no coolant leaking from any parts other than the engine water pump assembly. If there are leaks, inspect those areas.

·

Perform this inspection when the engine is cold.



a.

Visually check the engine water pump assembly.

i.

Check that engine coolant is not dripping from the engine water pump assembly.

HINT:
·

If engine coolant is dripping, replace the engine water pump assembly.

·

If engine coolant is not dripping, perform the following check.





b.

Inspect the area around the engine water pump assembly.

HINT:

Check for deposits around the drain hole of the engine water pump assembly.


i.
A337045C01
0.396,1.896 0.604,2.052 0.208,0.156 10 true *a 1.688,0.219 1.896,0.385 0.208,0.167 10 true *b
*a Drain Hole
*b Air Hole


Press a piece of paper towel against the drain hole or deposits around the drain hole and check that the paper towel is not wet.

HINT:
·

If the thin paper towel is wet, replace the engine water pump assembly.

·

If the thin paper towel is dry, clean the area around the engine water pump assembly.





Hide 16100 4.INSPECT ENGINE WATER PUMP ASSEMBLY

a.
A337046

Turn the water pump pulley and check that the water pump bearing moves smoothly and quietly.

If necessary, replace the engine water pump assembly.


Hide 16210 5.INSPECT FLUID COUPLING ASSEMBLY

a.
A337047

Remove the 4 nuts and fan from the fluid coupling assembly.


b.
A337048

Check that the fluid coupling assembly is not damaged and that no silicon oil leaks.

If necessary, replace the fluid coupling assembly.


c.

Install the fan to the fluid coupling assembly with the 4 nuts.

Torque:
6.5 N*m (66 kgf*cm, 58 in.*lbf)


Hide 11302 6.INSTALL NO. 1 TIMING BELT COVER

Hide 16711 7.INSTALL FAN SHROUD