Home › Engine / Hybrid System › 5L-E ENGINE CONTROL › DIESEL THROTTLE BODY › from 2016.01
RM3250E _51 Engine / Hybrid System _049910 5L-E ENGINE CONTROL _0244992 DIESEL THROTTLE BODY G

5L-E ENGINE CONTROL  DIESEL THROTTLE BODY  INSPECTION  


PROCEDURE

Hide 26100 1.INSPECT VENTURI ASSEMBLY

a.
A132685C01
0.099,0.033 0.344,0.235 0.245,0.203 10 *a
*a Component without harness connected
(Venturi Assembly)


Inspect the throttle control motor.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 18 to 22 Ω
2 - 3 20°C (68°F) 18 to 22 Ω
4 - 5 20°C (68°F) 18 to 22 Ω
5 - 6 20°C (68°F) 18 to 22 Ω


If the result is not as specified, replace the venturi assembly.



b.
A132686C01
0.137,0.077 0.4,0.273 0.263,0.196 10 *a
*a Component without harness connected
(Venturi Assembly)


Inspect the throttle open switch.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Fully open Below 1 Ω
1 - 2 Fully close 10 kΩ or higher


If the result is not as specified, replace the venturi assembly.