Home › Engine / Hybrid System › 5L-E ENGINE CONTROL › ACCELERATOR PEDAL › from 2016.01
RM3250E _51 Engine / Hybrid System _049910 5L-E ENGINE CONTROL _0244994 ACCELERATOR PEDAL G

5L-E ENGINE CONTROL  ACCELERATOR PEDAL  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 78110K 1.INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY

a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine / Data List / Accel Sensor Out No. 1 and Accel Sensor Out No. 2.

Powertrain > Engine > Data List
Tester Display
Accel Sensor Out No.1
Accel Sensor Out No.2
50003 234 280,281

e.

Read the value displayed on the GTS.

Standard Voltage:
Item Condition Specified Condition
Accel Sensor Out No. 1 Released 0.5 to 1.1 V
Depressed 2.6 to 4.5 V
Accel Sensor Out No. 2 Released 1.2 to 2.0 V
Depressed 3.4 to 4.75 V


If the result is not as specified, check the accelerator pedal sensor assembly, wire harness and ECM.