Home › Engine / Hybrid System › 5L-E ENGINE CONTROL › MANIFOLD ABSOLUTE PRESSURE SENSOR › from 2016.01
RM3250E _51 Engine / Hybrid System _049910 5L-E ENGINE CONTROL _0244998 MANIFOLD ABSOLUTE PRESSURE SENSOR G

5L-E ENGINE CONTROL  MANIFOLD ABSOLUTE PRESSURE SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89421C 1.INSPECT MANIFOLD ABSOLUTE PRESSURE SENSOR

a.

Check the terminal voltage.

i.

Disconnect the connector from the manifold absolute pressure sensor.


ii.

Turn the ignition switch to ON.


iii.
A241069C10
1.063,1.865 1.063,1.719 1.063,1.719 1.417,1.344 true 2.104,1.833 2.104,1.677 2.104,1.677 1.833,1.354 true 1.625,1.833 1.615,1.354 true 0.104,0.125 0.313,0.302 0.208,0.177 10 false *a 1.052,1.906 1.208,2.104 0.156,0.198 10 false E 1.51,1.896 1.823,2.094 0.313,0.198 10 false PIM 2.042,1.896 2.302,2.094 0.26,0.198 10 false VC
*a Front view of wire harness connector
(to Manifold Absolute Pressure Sensor)


Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
C89-3 (VC) - C89-1 (E) Ignition switch ON 4.75 to 5.25 V
C89-2 (PIM) - C89-1 (E) Ignition switch ON 3.0 to 5.0 V


If the result is not as specified, inspect the wire harness or ECM.


iv.

Connect the connector to the manifold absolute pressure sensor.



b.

Check the intake manifold pressure.

i.

Connect the GTS to the DLC3.


ii.

Turn the ignition switch to ON.


iii.

Turn the GTS on.


iv.

Enter the following menus: Powertrain / Engine and ECT / Data List / MAP.

Powertrain > Engine > Data List
Tester Display
MAP
50003 234 4

v.

Read the values displayed on the GTS.

OK:

Equivalent to atmospheric pressure.


HINT:
·

Standard atmospheric pressure is 101 kPa (abs) [758 mmHg (abs)].

·

For every 100 m (328 ft.) increase in altitude, pressure drops by 1 kPa (7.5 mmHg). This varies by weather.