28300
1.INSPECT STARTER RELAY (ST)
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 5 | Battery voltage not applied to terminals 1 and 2 | 10 kΩ or higher |
| Battery voltage applied to terminals 1 and 2 | Below 1 Ω |
If the result is not as specified, replace the starter relay.
28610
2.INSPECT GLOW PLUG RELAY (GLOW)
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 5 | Battery voltage not applied to terminals 1 and 2 | 10 kΩ or higher |
| Battery voltage applied to terminals 1 and 2 | Below 1 Ω |
If the result is not as specified, replace the glow plug relay.
3.INSPECT IG2 RELAY (IG2)
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 5 | Battery voltage not applied to terminals 1 and 2 | 10 kΩ or higher |
| Battery voltage applied to terminals 1 and 2 | Below 1 Ω |
If the result is not as specified, replace the IG2 relay.
82730
4.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
| *a | Component without harness connected
(Instrument Panel Junction Block Assembly) |
- | - |
Before performing the relay inspections for the relays of the instrument panel junction block assembly, inspect the EFI-MAIN NO. 1 fuse.
Remove the instrument panel junction block assembly.
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU(for LHD)>REMOVAL
Remove the body ECU from the instrument panel junction block assembly.
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU(for LHD)>REMOVAL
Inspect the EFI-MAIN NO. 1 relay.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2B-1 - 2G-5 | Battery voltage not applied to terminals 2P-9 and 2J-5 | 10 kΩ or higher |
| Battery voltage applied to terminals 2P-9 and 2J-5 | Below 1 Ω |
If the result is not as specified, replace the instrument panel junction block assembly.
Install the body ECU to the instrument panel junction block assembly.
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU(for LHD)>INSTALLATION
Install the instrument panel junction block assembly.
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU(for LHD)>INSTALLATION