The VC voltage (5 V) is generated in the ECM. The voltage is used to supply power to the manifold absolute pressure sensor and accelerator pedal position sensor.
For the circuit diagram of the ECM power source circuit.
Click hereEngine / Hybrid System>5L-E ENGINE CONTROL>ECD SYSTEM>ECM Power Source Circuit
VC Power Source Circuit
Check the fuses for circuits related to this system before performing the following inspection procedure.
Connect the GTS to the DLC3.
Turn the ignition switch to ON and GTS on.
Check the communication between the GTS and ECM.
| Condition | Proceed to |
|---|---|
| Communication is not possible | A |
| Communication is possible | B |
A
B
Turn the ignition switch to ON.
| *a | Component with harness connected
(ECM) |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G121-1 (+B) - C127-5 (E1) | IG ON | 11 to 14 V |
If the result is not as specified, since current is not flowing to the +B terminals of the ECM, the system may not be started.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the accelerator pedal position sensor connector.
Turn the ignition switch to ON.
Turn the GTS on.
Check the communication between the GTS and ECM.
It can be checked using the "Engine" item of the Data List.
| Result | Proceed to |
|---|---|
| Communication is possible | A |
| Communication is not possible | B |
Reconnect the accelerator pedal position sensor connector.
A
B
Disconnect the manifold absolute pressure sensor connector.
Turn the ignition switch to ON.
Turn the GTS on.
Check the communication between the GTS and ECM.
It can be checked using the "Engine" item of the Data List.
| Result | Proceed to |
|---|---|
| Communication is possible | A |
| Communication is not possible | B |
Reconnect the manifold absolute pressure sensor connector.
A
B
Disconnect the manifold absolute pressure sensor connector.
Disconnect the accelerator pedal position sensor connector.
Disconnect the ECM connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| C128-24 (VCPM) - Body ground and other terminals | Always | 10 kΩ or higher |
| G121-26 (VCPA) - Body ground and other terminals | Always | 10 kΩ or higher |
| G121-23 (VCP2) - Body ground and other terminals | Always | 10 kΩ or higher |
| G121-1 (+B) - Body ground and other terminals | Always | 10 kΩ or higher |
Reconnect the manifold absolute pressure sensor connector.
Reconnect the accelerator pedal position sensor connector.
Reconnect the ECM connector.
| Proceed to |
|---|
| OK |
| NG |
OK
NG