Home › Engine / Hybrid System › 5L-E ENGINE MECHANICAL › FRONT CRANKSHAFT OIL SEAL › from 2016.01
RM3250E _51 Engine / Hybrid System _049911 5L-E ENGINE MECHANICAL _0245946 FRONT CRANKSHAFT OIL SEAL A

5L-E ENGINE MECHANICAL  FRONT CRANKSHAFT OIL SEAL  INSTALLATION  


PROCEDURE

Hide 11301C 1.INSTALL FRONT CRANKSHAFT OIL SEAL

a.
A056913E03
1.438,1.188 1.438,1.521 true 1.26,1.531 1.563,1.677 0.302,0.146 10 false SST

Apply MP grease to the lip of a new front crankshaft oil seal.

NOTICE:
·

Keep the lip free of foreign matter.

·

Do not allow MP grease to contact the dust seal.




b.

Using SST and a hammer, tap in the front crankshaft oil seal.

SST
09214-60010  

NOTICE:
·

The acceptable depth from the top of the timing belt case sub-assembly edge is 0.5 mm (0.0197 in.)

·

Keep the lip free from foreign matter.

·

Do not tap the front crankshaft oil seal at an angle.

·

Make sure that the front crankshaft oil seal is properly installed.




Hide 13521P 2.INSTALL CRANKSHAFT TIMING PULLEY

a.
A056897C01
2.135,1.208 2.51,1.583 true 2.354,1.615 2.781,1.875 0.427,0.26 10 false SST 1.198,0.042 1.396,0.219 0.198,0.177 10 false *a
*a Inside


Align the keyway of the crankshaft timing pulley with the crankshaft timing pulley set key located on the crankshaft, and then slide the crankshaft timing pulley into place to install it.


b.

Using SST and a hammer, tap in the crankshaft timing pulley with the flange side facing inward.

SST
09223-46011