Home › Engine / Hybrid System › 5L-E ENGINE MECHANICAL › CYLINDER BLOCK › from 2016.01
RM3250E _51 Engine / Hybrid System _049911 5L-E ENGINE MECHANICAL _0245951 CYLINDER BLOCK A

5L-E ENGINE MECHANICAL  CYLINDER BLOCK  REPAIR  


PROCEDURE

Hide 11401 1. BORE CYLINDER

HINT:
·

Bore all 4 cylinders to fit the O/S piston outside diameter.

·

Replace all the piston rings with ones to match the O/S pistons.



a.

Prepare 4 new O/S pistons.

Standard piston diameter:

99.95 to 99.98 mm (3.935 to 3.936 in.)



b.
A057046C04
2.344,0.615 2.469,0.219 2.469,0.219 2.583,0.219 true 1.917,0.458 1.729,0.135 1.729,0.135 1.531,0.135 true 2.708,1.406 3.083,1.604 0.375,0.198 10 false *c 2.604,0.125 2.927,0.354 0.323,0.229 10 false *b 1.344,0.042 1.583,0.24 0.24,0.198 10 false *a
*a Front Mark (Arrow)
*b Size Mark
*c Distance


Using a micrometer, measure the piston diameter at right angles to the piston pin center line where the distance from the piston head is as specified.

Standard distance:

61.27 to 61.33 mm (2.412 to 2.415 in.)



c.

Calculate the amount each cylinder is to be rebored as follows.

Size to be rebored:

Size to be rebored = P + C - H

P = Piston diameter

C = Piston clearance: 0.04 to 0.06 mm (0.00157 to 0.00236 in.)

H = Allowance for honing: 0.02 mm (0.000787 in.) or less



d.

Bore and hone the cylinders to the calculated dimensions.

Maximum honing:

0.02 mm (0.000787 in.)


NOTICE:

Excess honing will destroy the finished roundness.