Home › Engine / Hybrid System › 5L-E STARTING › GLOW PLUG › from 2016.01
RM3250E _51 Engine / Hybrid System _049917 5L-E STARTING _0248608 GLOW PLUG A

5L-E STARTING  GLOW PLUG  INSTALLATION  


PROCEDURE

Hide 19850 1.INSTALL GLOW PLUG ASSEMBLY

a.

Using a 12 mm deep socket wrench, install the 4 glow plug assemblies.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)


Hide 19871 2.INSTALL NO. 1 GLOW PLUG CONNECTOR

a.

Install the No. 1 glow plug resistor insulator.


b.

Install the No. 1 glow plug connector by uniformly tightening the 4 nuts.

Torque:
1.0 N*m (10 kgf*cm, 9 in.*lbf)


c.

Install the 4 screw grommets.


d.

Connect the engine wire and install the No. 2 glow plug resistor insulator and plate washer with the nut.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


Hide 17130 3.INSTALL INTAKE PIPE

a.

Temporarily install the intake pipe.


b.
A118426C01
0.479,1.146 0.729,1.323 0.25,0.177 10 true *a 2.823,0.385 3.073,0.563 0.25,0.177 10 true *b 1.76,1.906 2.01,2.083 0.25,0.177 10 true *c 1.052,1.896 1.302,2.073 0.25,0.177 10 true *c
*a Hose Clamp A
*b Hose Clamp B
*c Bolt


Install the 2 bolts.

Torque:
18 N*m (184 kgf*cm, 13 ft.*lbf)


c.

Tighten the 2 hose clamps to secure the intake pipe.

Torque:
for hose clamp A : 4.0 N*m (41 kgf*cm, 35 in.*lbf)
for hose clamp B : 6.0 N*m (61 kgf*cm, 53 in.*lbf)


Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION