Home › Engine / Hybrid System › 5L-E STARTING › STARTER › from 2016.01
RM3250E _51 Engine / Hybrid System _049917 5L-E STARTING _0248609 STARTER A

5L-E STARTING  STARTER  REASSEMBLY  


PROCEDURE

Hide 28160 1.INSTALL STARTER ARMATURE ASSEMBLY

a.
P004699

Using a press, press in the starter armature assembly.


Hide 28140 2.INSTALL STARTER BRUSH HOLDER ASSEMBLY

a.
ST00096

Align the claw of the starter brush holder assembly with the claw groove of the starter yoke assembly.


b.
N000562

Install the 4 starter brushes to the starter brush holder assembly.

i.

Using a screwdriver, pull back the spring.


ii.

Install the starter brush to the starter brush holder assembly.

NOTICE:

Check that the positive (+) lead wires are not grounded.




Hide 28150 3.INSTALL MAGNET STARTER SWITCH ASSEMBLY

a.

Apply high-temperature grease to the starter idler pinion, starter armature pinion, steel ball, return spring, clutch roller and retainer.


b.
A197147

Install the steel ball to the hole of the starter clutch sub-assembly.


c.

Insert the return spring into the hole of the starter clutch sub-assembly.


d.

Install the clutch roller, retainer, starter idler pinion, starter armature pinion and starter clutch sub-assembly to the starter drive housing.


e.

Install the magnet starter switch assembly to the starter drive housing with the 2 screws.

Torque:
9.3 N*m (95 kgf*cm, 82 in.*lbf)


Hide 28120 4.INSTALL STARTER YOKE ASSEMBLY

a.

Install the 2 new O-rings to the 2 bolts.


b.

Install a new O-ring to the groove of the starter yoke assembly.


c.
B000463C01
2.063,1.49 2.833,1.083 2.833,1.083 3,1.083 true 2.313,1.771 2.833,1.083 true 2.646,1.833 2.833,1.083 true 2.844,1.615 2.833,1.083 true 0.813,0.583 0.469,1.031 0.469,1.031 0.313,1.031 true 1.271,0.135 1.104,0.135 1.104,0.135 0.938,0.479 true 3.042,0.99 3.313,1.167 0.271,0.177 10 false *a 0.135,0.948 0.406,1.125 0.271,0.177 10 false *b 1.313,0.052 1.583,0.229 0.271,0.177 10 false *c
*a Claw
*b Punch Mark
*c Line


Align the claws of the starter brush holder assembly with the grooves of the magnet starter switch assembly.


d.

Install the starter yoke assembly with the starter armature assembly.


e.

Align the punch mark of the starter yoke assembly with the line of the magnet starter switch assembly.


f.

Install the 2 bolts.

Torque:
12.7 N*m (130 kgf*cm, 9 ft.*lbf)


g.

Connect the lead wire to terminal C with the nut.

Torque:
5.9 N*m (60 kgf*cm, 52 in.*lbf)


Hide 28139 5.INSTALL STARTER LEAD WIRE

a.

Install the starter lead wire with the screw.

Torque:
3.6 N*m (37 kgf*cm, 32 in.*lbf)