Home › Engine / Hybrid System › 2TR-FE ENGINE CONTROL › HEATED OXYGEN SENSOR › from 2016.01
RM3250E _51 Engine / Hybrid System _038021 2TR-FE ENGINE CONTROL _0183980 HEATED OXYGEN SENSOR A

2TR-FE ENGINE CONTROL  HEATED OXYGEN SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the heated oxygen sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Gas leaks from exhaust system Inspection After Repair Poor idle, engine start, etc. (Click here)

CAUTION:
A350542

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


PROCEDURE

Hide 89465 1.REMOVE HEATED OXYGEN SENSOR

CAUTION:

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


a.
A356162C01
0.042,0.167 0.354,0.323 0.313,0.156 10 true *A 0.042,2.458 0.354,2.615 0.313,0.156 10 true *B
*A for 2WD and Pre-Runner
*B for 4WD


Disconnect the heated oxygen sensor connector.


b.

for 2WD and Pre-Runner:

Detach the sensor wire from the 4 clamps.


c.

for 4WD:

Detach the sensor wire from the clamp.


d.
A356163C01
1.938,0.948 2.167,0.667 2.167,0.667 2.333,0.667 true 1.854,3.344 2.083,3.083 2.083,3.083 2.25,3.083 true 0.052,0.146 0.365,0.302 0.313,0.156 10 true *A 0.042,2.469 0.354,2.625 0.313,0.156 10 true *B 2.333,0.583 2.667,0.75 0.333,0.167 10 true SST 2.25,3 2.583,3.167 0.333,0.167 10 true SST
*A for 2WD and Pre-Runner
*B for 4WD


Using SST, remove the heated oxygen sensor.

SST
09224-00011