Home › Engine / Hybrid System › 2KD-FTV STARTING › STARTER(for BOSCH Made) › from 2016.01
RM3250E _51 Engine / Hybrid System _038020 2KD-FTV STARTING _0249489 STARTER(for BOSCH Made) G

2KD-FTV STARTING  STARTER(for BOSCH Made)  INSPECTION  


PROCEDURE

Hide 28100 1.INSPECT STARTER ASSEMBLY

CAUTION:

As a large electric current passes through the cable during this inspection, a thick cable must be used. Otherwise, the cable may become hot and cause injury.


NOTICE:

The following tests must each be performed within 3 to 5 seconds to prevent the coil from burning out.


a.

Mount the starter in a vise between aluminum plates.


b.
A369647C01
2.156,0.865 2.333,0.5 2.333,0.5 2.5,0.5 true 2.083,1.042 2.083,2.25 2.083,2.25 2.25,2.25 true 2.573,0.427 2.885,0.625 0.313,0.198 10 false *1 2.292,2.177 2.604,2.375 0.313,0.198 10 false *2
*1 Terminal 50
*2 Terminal C
V100135

Moves outward


Perform a pull-in test.

i.

Remove the nut, and then disconnect the lead wire from terminal C.


ii.

Connect the battery to the magnet starter switch as shown in the illustration. Then check that the clutch pinion gear moves outward.

If the clutch pinion gear does not move, replace the magnet starter switch assembly.



c.
A369648C01
1.417,2.25 1.583,2.25 1.583,2.25 1.979,1.427 true 1.25,2.188 1.563,2.385 0.313,0.198 10 false *1
*1 Terminal C
V100135

Disconnect


Perform a holding test.

i.

Disconnect the negative (-) terminal lead from terminal C with the condition specified in the pull-in test above being maintained. Check that the pinion gear remains out.

If the clutch pinion gear returns inward, replace the magnet starter switch assembly.



d.
A372355C01
0.635,1.073 0.792,1.271 0.156,0.198 10 false .
V100135

Disconnect
V100136

Returns inward


Inspect the clutch pinion gear return.

i.

Disconnect the negative (-) lead from the starter body. Check that the clutch pinion gear returns inward.

If the clutch pinion gear does not return inward, replace the magnet starter switch assembly.



e.

Perform an operation test without load.

i.

Connect the lead wire to terminal C.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


ii.
A372356C01
2.667,1.25 2.667,0.5 2.667,0.5 2.5,0.5 true 2.479,1.396 1.979,2.396 1.979,2.396 1.813,2.396 true 2.344,0.427 2.656,0.625 0.313,0.198 10 false *1 1.625,2.323 1.938,2.521 0.313,0.198 10 false *2
*1 Terminal 30
*2 Terminal 50


Connect the battery and an ammeter to the starter as shown in the illustration.


iii.

Check that the starter rotates smoothly and steadily while the pinion gear is moving outward. Then measure the current.

Standard current:

123 A or less at 10.9 V


If the result is not as specified, replace the starter assembly.