Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM PUMP(for 5L-E) › from 2016.01
RM3250E _54 Brake _038045 BRAKE SYSTEM (OTHER) _0250463 VACUUM PUMP(for 5L-E) G

BRAKE SYSTEM (OTHER)  VACUUM PUMP(for 5L-E)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1. OPERATION CHECK

a.

Disconnect the vacuum hose from the vacuum pump assembly.


b.
C106115C01
2.719,0.438 2.719,0.26 2.719,0.26 3.021,0.26 false 3.01,1.917 3.24,1.917 3.24,1.917 3.24,1.719 false 3.063,0.177 3.271,0.365 0.208,0.188 10 false *a 2.813,1.844 2.99,2.01 0.177,0.167 10 false *b
*a Vacuum Gauge
*b Plug


Connect the hose of the vacuum gauge to the vacuum pump assembly.


c.

Insert a plug into the other hose of the gauge.


d.

Start the engine and warm it up for more than 2 minutes.


e.

With the engine idling, check the negative pressure of the vacuum pump assembly.

Standard pressure:

More than 87 kPa (650 mmHg, 25.6 in.Hg)


HINT:

The vacuum pump assembly is listed as one of the 200000 km (124000 mile) maintenance parts. Make sure to disassemble and inspect it every 200000 km (124000 miles) and replace parts as necessary.



f.

Remove the vacuum gauge from the vacuum pump assembly.


g.

Connect the vacuum hose to the vacuum pump assembly.